Dash board and Dash Panel/Instrument Bulbs
BA7s is a 7mm cap with parallel pins and a single contact which is live, the cap body being earth commonly used in post 1955 vehicles
BA9s is a 9mm cap with parallel pins and a single contact which is live, the cap body being earth commonly used in post 1960 vehicles
E10 MES is a 10mm wide screw in fitting with 1 contact on the bottom the same as an old fashioned torch bulb
T10 is a 10mm wide push in fitting with 2 wire contacts often found in dashboards on 1970's and 1980's vehicles
BA15d is a 15mm cap with parallel pins and 2 contacts of which one is live and the other is earth often used in pre 1930 cars and some 1930's higher quality cars
BA15s is a 15mm cap with parallel pins and one contact which is live, the cap body being earth, commonly used in 1930's/40's dash lamps
Part No. 1
BA9s WHITE - BI POLARITY
Direct replacement.
6/12v diffused multi voltage - Super bright
Use in numberplate lights
Use in sidelights and dashboard lights
Excellent light spread.
Dimmable.
Replaces parallel pin type filament bulbs

Part No. 2
BA9s white - 12v NEG EARTH only
This amazing little LED bulb looks every bit like a standard original filament bulb!
Ideal for dashboard illumination, side lights or number plate.
Shines its light all round.
Exactly the same size as an original bulb
Dimmable
Part No. 3
E10 MES white screw in type
Direct replacement. 180 degree light spread
Two types
1 LED - Replaces 2.2w bulbs (Left)
NEWDIFF - Super bright for dash panel/numberplate and sidelights (Right)
1 LED is the same size as a std bulb
NEWDIFF is marginally longer
Replaces earlier type speedo filament bulbs
Part No. 4
E10 MES GREEN or BLUE Screw in type.
12v 2.2w bi-polarity.
Will give full brightness down to 3v so also suitable for 6v systems.
Direct replacement.
Gives a nice blue or green backlight to dashboards and individual clocks.
Same size as original bulbs
Replaces dash panel bulbs.
Dimmable.

Part No. 5
T10 wedge fitting. 5w white - Bi-polarity - Diffused
One bulb works on 6v and 12v!
Shines a bright, white light all round
Direct replacement ultra low power consumption LED bulb
Replaces standard T10 filament bulbs
Overall length 29mm
Ideal for side lights, dashboards and individual clocks and gauges
Part No. 6
5w White - 12 LED
BA15s or BA15d fittings. Shines a white light all round
Direct replacement ultra low power consumption 12 SMD LED bulb.
Replaces parallel pin filament bulbs.
For use behind older dash boards and in Lucas type twist on/off panel lamps
Part No. 7
BA7s 2w 7mm bayonet type
Direct replacement.
140 degree light spread.
Replaces filament bulbs
Commonly used in overdrive switches etc.
6 AND 12v NEGATIVE AND POSITIVE EARTH